EC 145

1/4 Inch Drive Metric Torque Adapters
P/N TORQMET
$110.00
This set of 1/4" drive torque adapters is like our SAE Torque adapters but in metric sizes.
This set consists of 6, 8, 10 and 13 mm. This was requested by an EC mechanic that indicated these were the most
common sizes. I have very little time on the metrics so you have to tell me what you need.
Other sizes are available up to 14mm.
Call or email with the size you need.
P/N TORQMET
$110.00
This set of 1/4" drive torque adapters is like our SAE Torque adapters but in metric sizes.
This set consists of 6, 8, 10 and 13 mm. This was requested by an EC mechanic that indicated these were the most
common sizes. I have very little time on the metrics so you have to tell me what you need.
Other sizes are available up to 14mm.
Call or email with the size you need.

EC145 Engine Oil Drain
P/N EC145ENGOIL
$85.00
Comes with a 7 ft. hose
P/N EC145ENGOIL
$85.00
Comes with a 7 ft. hose

Brass Screwdriver for Compass Adjustment
P/N BRASSCA
$23.00
No more trying to make a screw driver for adjusting compasses with a hammer and welding rod.
This is a quality, solid brass screwdriver made especially for adjusting compasses.
It's 4 3/4 inches long and the blade tip is 5/32" wide.
P/N BRASSCA
$23.00
No more trying to make a screw driver for adjusting compasses with a hammer and welding rod.
This is a quality, solid brass screwdriver made especially for adjusting compasses.
It's 4 3/4 inches long and the blade tip is 5/32" wide.

EC-145 Hydraulic Module Plunger Work Aid
P/N 145HMP
$185.00
This hydraulic module plunger work aid is designed for the aft facing hydraulic module on the 145 series aircraft. The older style plunger work aid is too large to fit between the transmission and hydraulic module. This work aid is required if you want to do the job right without damaging anything. It will work on both 145 and 135 hydraulic modules.
P/N 145HMP
$185.00
This hydraulic module plunger work aid is designed for the aft facing hydraulic module on the 145 series aircraft. The older style plunger work aid is too large to fit between the transmission and hydraulic module. This work aid is required if you want to do the job right without damaging anything. It will work on both 145 and 135 hydraulic modules.