Helicopter Work Aids
  • Home
    • About Us
    • FAQ
    • Free Drains
  • Bell
    • Bell 206
    • Bell 407
    • Bell 429
    • Bell 505
    • Bell 212
    • Bell 222
    • Bell 412
    • Bell 427
  • Sikorsky
    • S-76
    • S-70 / UH-60
    • S-92
    • S-58
  • Other Airframes
    • BO 105
    • BO 117
    • AS 350
    • AW 109
    • AW 119
    • EC 120
    • EC 135
    • EC 145
    • MD500
    • Robinson
  • Powerplants
  • Contact
  • Non-Specific
    • Honda
    • Swing Wrenches

Robinson


Picture
Rolls-Royce RR300 Seal Installer 
P/N 250SGSI
$140.00

This is the new seal installer from Rolls-Royce's Commercial Service Letter. This was designed for installing the new lip seals (23091467) which include a supplied installation mandrel.


Picture

52 inches long X 1/4 inch Drive Extension

P/N 52EXTENSION

$125.00

​This extension is to R&R the 2 AN-3's inside the t/boom that hold the support for the t/r d/shaft.
​It comes with a 3/8" 12 point socket with a magnet inside to hold the bolts in place.
You no longer need to use multiple extensions that flop around or weld yours together.
​This is a 3/8 OD steel tube with .065" wall thickness. A 1/4 drive extension has been cut and welded inside the tube. The tube is lighter than the 4 or 5 extensions welded together and probably a lot straighter. Due to the length it was hard to get a good pic so you might have to use your imagination to
visualize or just give us a call @ 318-308-0643





Picture
Rolls-Royce 300 Fwd and Aft PTO Seal Installer
P/N R66SI
$1050.00

Name describes it all.


Picture
Rolls-Royce 300 Fwd and Aft PTO Seal Remover
P/N R66SR
$2000.00

Name describes it all.


Picture
R22 & R44 Fan Driveshaft Flange Puller
P/N R22FDP
$375.00

Easily remove the driveshaft flange for inspections with this work aid.



Picture
Brass Screwdriver for Compass Adjustment
P/N BRASSCA
$23.00

No more trying to make a screw driver for adjusting compasses with a hammer and welding rod.
This is a quality, solid brass screwdriver made especially for adjusting compasses.
It's 4 3/4 inches long and the blade tip is 5/32" wide.


Picture
Robinson Rotor Head Bolt Stretch Gauge 

P/N to be 
determined 

We have for the R22 and 44.

More info to be listed soon



Picture
Robinson Teeterbar
P/N HWAMT354-1 (R22 only) 
​P/N HWAMT354-4 (R44 & R66) 
$50.00 (only one)


Picture
Spindle Boot Plate
P/N HWAMT549-2
$50.00


Picture
Sheave Alignment Bar
P/N MT331-4
$35.00




Picture
Robinson Spark Plug Ignition Cable Wrench
P/N R22SPW
$20.00


Picture
Robinson R22 Clutch Micro Switch Swing Wrenches
P/N R22CSW
$90.00

1/4 in box end with a 3/8 in open end swing wrench for adjusting the clutch micro switch.

Picture

Picture