A collection of male and female threads in SAE and Metric.
If you are not well versed in thread identification, this is the item you have been looking for.
We have this torque stripe in orange only
These reversible swing wrenches are an improvement over our other wrenches.
We are using the reversible Gear wrench brand so when you get into a tight spot and can't get the wrench off the nut or bolt you can simply flip the reversing lever and back out...
No more trying to make a screw driver for adjusting compasses with a hammer and welding rod.This is a quality, solid brass screwdriver made especially for adjusting compasses.It's 4 3/4 inches long and the blade tip is 5/32" wide.
These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in.
I recently found this 90 degree grease coupler that works great on hard to access grease fittings.Works really well on the oil cooler blower bearings on the Bell 407.
It slides in from the side when straight on access is difficult or next to impossible.
Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter.
The standard set consists of 1/4", 5/16", 3/8", &...
Typical engine oil drain.
Comes with a 7 ft hose.
Transmission quill drain for all the variations of the 222 airframe as it progressed to the 430.This drain has the hose attached at a 90 degree angle for clearance with a 7 ft hose.
I worked on the 222 many years ago and don't remember...
Tail rotor gearbox drain for all the variations of the 222 airframe as it progressed to the 430.Typical drain with the 7 ft hose.
One Black Plastic "Church Key" FOD Free Turbine Oil Can Opener
Fixture to hold Tail Rotor Gearbox.
Used to remove, install and torque locknut on Tail Rotor Gearbox.
© 2023 Helicopter Work Aids
All rights reserved.