429 Main Rotor Torque Multiplier Fixture Main rotor assembly fixture for torquing the mast nut Bell P/N 429-210-001-101 MSRP: Was: Now: $5,500.00 Add to Cart
10X Magnifying Glass We chose this model of magnifying glass because the cup is setup for the correct focal distance. Just place the magnifying glass on the object you are trying to inspect and you are focused. No fighting the loupe trying to figure out the correct focus... MSRP: Was: Now: $20.00 Add to Cart
429 Main Rotor Hub Cone Set 3 Jaw Puller This is a 3 jaw puller that the maintenance manual calls out for to remove the cone set from the main rotor hub. Our tool also comes with the stepper plate required (Its just not pictured). MSRP: Was: Now: $500.00 Add to Cart
429 Main Rotor Head Stand Table top head stand for performing maintenance and overhaul procedures on the 429 main rotor head.Bolt to your table with 4 ea 5/8 bolts. MSRP: Was: Now: $1,200.00 Add to Cart
429 Main Rotor Head Puller We designed this puller after receiving reports that the 429 is having problems with head removal. Remove the mast nut and four hub through bolts. Place pressing plug on the mast. Install the puller plate with the aluminum spacers underneath it. Then... MSRP: Was: Now: $650.00 Add to Cart
429 Main Rotor Pitch Change Link Trammel Accurate, simple trammel for the 429 main rotor pitch change links. This trammel will outperform other universal trammels. MSRP: Was: Now: $480.00 Add to Cart
429 Idler Link Bushing R&R Remove and replace the ilder link bushings as per the maintenance manual. MSRP: Was: Now: $385.00 Add to Cart
429 Swashplate Shim Alignment Studs - 7pcs set Holds the shims in position when doing the swashplate friction check. The hex head is 5/32" drive. An allen wrench is easier to get in to tight areas than a long phillips screwdriver. Can also be used as jackscrews where a 1/4 28 jackscrew is needed. MSRP: Was: Now: $25.00 Add to Cart
429 Main Rotor Blade Sling Main rotor blade sling aids in safely removing and installing main rotor blades. The 429 puts you at the upper limits of safely R&R the main rotor blades due to the hight of the blades, your work stands and short mechanics. Even a tall guy has to... MSRP: Was: Now: $2,100.00 Add to Cart
