Input seal installer for the main gearbox.
A collection of male and female threads in SAE and Metric.
If you are not well versed in thread identification, this is the item you have been looking for.
We have this torque stripe in orange only
These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in.
I recently found this 90 degree grease coupler that works great on hard to access grease fittings.Works really well on the oil cooler blower bearings on the Bell 407.
It slides in from the side when straight on access is difficult or next to impossible.
Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter.
The standard set consists of 1/4", 5/16", 3/8", &...
Twist Grip Drive Tube and Control Pinion Attachment Work AidP/N: ASB76A006Used to check correct bonding strength of the control pinion on the pilot and copilot collective lever driver tubes.
Drain hose for the M01 and M05 modules. Comes with a 7 foot hose.
The AS350 engine oil and hydraulic oil tanks use the same drain.This drain comes with a 7 ft hose just like all the rest.
Not much to say here except that it comes with a 7 ft hose.Stick it in the hole and the oil runs out.
Just like all the others except different.
Installs and seats the seal into the flange housing with air pressure.
For those of you familiar with shimming the AS350 series swashplate you've probably had to rent this before and know what it is.
$200/Day - Rent starts upon arrival at your location
AirBus no longer offers this kit for rent.
One Black Plastic "Church Key" FOD Free Turbine Oil Can Opener
Has 2 sets of bolt patterns to fit Main Gearbox Input Flange, Brake Disc, Tail Rotor Gearbox Input Flange, and Engine Flanges.
© 2023 Helicopter Work Aids
All rights reserved.