Work aids to assist in removing bushings on spindles
Used to remove the bearing from the main rotor damper.
A collection of male and female threads in SAE and Metric.
If you are not well versed in thread identification, this is the item you have been looking for.
We have this torque stripe in orange only
These reversible swing wrenches are an improvement over our other wrenches.
We are using the reversible Gear wrench brand so when you get into a tight spot and can't get the wrench off the nut or bolt you can simply flip the reversing lever and back out...
No more trying to make a screw driver for adjusting compasses with a hammer and welding rod.This is a quality, solid brass screwdriver made especially for adjusting compasses.It's 4 3/4 inches long and the blade tip is 5/32" wide.
These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in.
Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter.
The standard set consists of 1/4", 5/16", 3/8", &...
S70/UH-60 Landing Gear Strut Lower-Attach Bolt WrenchP/N: S70LGWDesigned to be a better and tighter fit than a crowsfoot.
S70/UH-60 Landing Gear Strut Servicing TowerCall For PriceThis 8' tower is designed to speed up the servicing of the strut by allowing you to work on the strut out in the open and not on an aircraft that is on jacks 4 feet in the air.
Comes with 7 foot hose.
Blackhawk Door Storage RackP/N: UH60DRThis rack was made for the local guard unit. It holds up to 8 doors.Specify the number of door slots needed.CALL FOR PRICING
© 2023 Helicopter Work Aids
All rights reserved.