This kit contains the following items:
Mast Assembly Holding Fixture 407-240-008-101
Mast Assembly Nut Wrench 407-240-007-101
Bearing removal plate T103318
Work Aid #1 & #2
Work Aid #3
Foam and case
A collection of male and female threads in SAE and Metric.
If you are not well versed in thread identification, this is the item you have been looking for.
We have this torque stripe in orange only
These reversible swing wrenches are an improvement over our other wrenches.
We are using the reversible Gear wrench brand so when you get into a tight spot and can't get the wrench off the nut or bolt you can simply flip the reversing lever and back out...
No more trying to make a screw driver for adjusting compasses with a hammer and welding rod.This is a quality, solid brass screwdriver made especially for adjusting compasses.It's 4 3/4 inches long and the blade tip is 5/32" wide.
These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in.
I recently found this 90 degree grease coupler that works great on hard to access grease fittings.Works really well on the oil cooler blower bearings on the Bell 407.
It slides in from the side when straight on access is difficult or next to impossible.
Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter.
The standard set consists of 1/4", 5/16", 3/8", &...
Used to move the blade and grip when trying to re-connect the pitch change links.
Used with your choice of a 4-1 or 3-1 torque multiplier. 407 back up pin in use.
Let the torque multiplier bump up against the pin to hold backup.This pin lets you do the mast nut torque or 1-5 hr torque check by yourself not to mention holding...
Transmission drain also comes with 7 foot hose.
427 tail rotor gearbox drain comes with the 7 foot hose just like the other drains.
These are made when ordered. These do not move as fast so we don't keep them in stock.
One Black Plastic "Church Key" FOD Free Turbine Oil Can Opener
Used to make adjustments on main rotor trim tabs during tracking.
Comes with protective case.
Bell P/N T103316 & T103317
© 2023 Helicopter Work Aids
All rights reserved.