206/407/505 Swashplate Roll Stake Bearing Work Aid Kit MSRP: Was: Now: $250.00 - $3,000.00 Choose Options
Swashplate Gimbal Ring Bolt Removal Workaid (204B, 205, 212 & 412) MSRP: Was: Now: $300.00 Add to Cart
206/407/505 Swashplate Roll Stake Bearing Work Aid Kit Bearing staking tool for the swashplate bearings. Allows you to perform the maintenance on the aircraft without removing the swashplate. T101530 MSRP: Was: Now: $250.00 - $3,000.00 Choose Options
Spring Scale 0-50lbs 0-50 lbs Spring Scale. This spring scale is made of brass and will not shatter in your tool box like the cheap plastic spring scales. I've used both, brass and the plastic case spring scales. They both work. I just prefer the brass since they are a... MSRP: Was: Now: $110.00 Add to Cart
206 Trim Tab Bender Used to bend the trim tabs during track & balance. MSRP: Was: Now: $1,500.00 Add to Cart
Bolt Extractor This work aid lets you apply pressure to the bolt while applying penetrating lube. Once the bolt pops loose it can easily be removed. Pressure is applied to the bolt and not to the tail boom fitting. Cracked fittings require tail boom removal at lots of... MSRP: Was: Now: $225.00 Add to Cart
Swashplate Shim Alignment Studs Holds the shims in position when doing the swashplate friction check. The hex head is 5/32" drive.An allen wrench is easier to get in to tight areas than a long phillips screwdriver. Can also be used as jack screws on the 206 and 407 transmission input... MSRP: Was: Now: $20.00 Add to Cart
206 Main Rotor Hub Pitch Horn Lock Use this work aid when lifting the hub assembly from the mast. Remove upperside of pitch control links and install the work aid. MSRP: Was: Now: $425.00 Add to Cart
206 Swashplate Uniball Fixture Supports lower portion of uniball when pressing in the lower bushings. MSRP: Was: Now: $150.00 Add to Cart
206 Swashplate Uniball Lower Bushing Remover Removes lower bushings from swashplate uniball. MSRP: Was: Now: $55.00 Add to Cart
Torque Adapters 1/4" Drive Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter. SAE: The standard set consists of 1/4", 5/16", 3/8", &... MSRP: Was: Now: $50.00 - $170.00 Choose Options
Swashplate Gimbal Ring Bolt Removal Workaid (204B, 205, 212 & 412) Swashplate Gimbal Ring Bolt Removal Workaid (204B, 205, 212 & 412) 204B-22-27 205-22-45 205B-22-29 212-22-74 412-22-93 MSRP: Was: Now: $300.00 Add to Cart
206/505 Tail Rotor Rigging Flap Lock Work Aid Bell designed flap lock for 206/505. These were acquired through purchase of HeliTools inventory. Limited supply. See our design here. MSRP: Was: Now: $25.00 Add to Cart
