MD Helicopters

9 of 9 Items
  • Composite Tap Hammer Composite Tap Hammer Composite Tap Hammer

    Composite Tap Hammer

    Use the tap hammer on main rotor blades or any other composite material to check for delamination.   You can order somewhere else for $15 + $12 shipping ($27 total) or just bundle with your next order with us.   Equivalent to T75449-2

    $24.00
    Add to Cart
  • Grease Fitting - 90°

    Grease Fitting - 90°

    These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in.

    $20.00
    Add to Cart
  • 90° Grease Coupler 90° Grease Coupler

    90° Grease Coupler

    I recently found this 90 degree grease coupler that works great on hard to access grease fittings.Works really well on the oil cooler blower bearings on the Bell 407. It slides in from the side when straight on access is difficult or next to impossible.

    $16.00
    Add to Cart
  • MD500 Main Rotor Upper Scissor Crank Bearing R&R MD500 Main Rotor Upper Scissor Crank Bearing R&R MD500 Main Rotor Upper Scissor Crank Bearing R&R

    MD500 Main Rotor Upper Scissor Crank Bearing R&R

    R&R main rotor scissor crank bearing without wasting time trying to find sockets and bolts to press the bearing in and out. ​It has been brought to my attention that after several bearings have been changed that the bore tends to...

    $60.00
    Add to Cart
  • MD500 Main Rotor Lower Scissor Crank Bearing R&R MD500 Main Rotor Lower Scissor Crank Bearing R&R MD500 Main Rotor Lower Scissor Crank Bearing R&R MD500 Main Rotor Lower Scissor Crank Bearing R&R

    MD500 Main Rotor Lower Scissor Crank Bearing R&R

    R&R the lower scissor crank bearing. This consists of installer and remover for the lower scissor. Due to the tight outer ear we had to make a fitting to clear the curved edge when installing the bearing.Removal only requires the receiver and bolt.

    $95.00
    Add to Cart
9 of 9 Items

© 2025 Helicopter Work Aids All rights reserved.